3M Company has 12 OSHA inspections on record in Wisconsin, the first in 1974.
OSHA's last visit started on Jul 23, 2025 on a referral, in Menomonie, and the case has not closed yet.
Across those inspections OSHA issued 20 citation items: 7 serious, 3 repeat and 10 other-than-serious.
OSHA proposed $308,121 in penalties and the amount has not been reduced.
Most often, OSHA cited 1910.1200, hazard communication (5 items).
For context, across all manufacturing employers the median penalty per cited inspection since 2015 is $4,500. 3M Company averages $153,643 over 3 cited inspections in that time.
1 inspection on this page followed a fatal incident.
3M Company also files yearly injury logs with OSHA, summarized below.
It reported 2 severe injuries to OSHA since 2015.
The Wage and Hour Division has 2 cases on it since 2015, with $70,000 in back wages owed to workers.
Citation items per year, by inspection date.
Wisconsin · latest 90 days of OSHA records
229employers cited
Get notified the morning OSHA posts each new citation in Wisconsin: the employer, the site address, the rules broken and the penalty.
OSHA records show 3M Company at 40 sites in 12 states. Together they've had 113 inspections and $789,466 in current penalties.
We match records by employer name and industry, so these sites are likely the same company, not certainly. Franchises and subsidiaries can file under one name.
Included with any plan: the site-by-site record for all 40 sites, with repeat and willful violations and citations per year for the whole company. Already a subscriber? Sign in.
Incident on May 9, 2023 (fatal): Employee is killed when caught in operating rollers of extru
At 6:30 a.m. on May 9, 2023, Employee #1, a machine operator, was setting up an extrusion line threading material through rollers at roller station 1 of the line. A step of the set up involves employees threading, by hand, the material through roll stations (pull stations). The rollers of the roll station are in operation/moving during thread up/set up. The machine is not turned off or shut down. The rolls are programmed to turn/rotate at certain speeds so the desired end product is satisfactory and so the fibers don't break or wrap up. Speeds of the rollers at roll station 1 were programmed to be 96 feet per minute (fpm). There is an interlocked physical safety gate/door at roll station 1 located at the front of the rollers, where the employees stand to guide the tow through the rollers during set up/thread up. The door is opened or in the raised position while employees thread the tow through the rollers at the roll station. Employee #1, machine operator, was assisting with setting up the 2A fiber extrusion line. Employee #1 was in training and assisted with set up and treading the machine prior to and was observing the rollers at roller station 1, when employee 1 became caught in or between the material and rollers, resulting in traumatic head injuries. Employee #1 was killed. The event occurred indoors, and weather was likely not a factor contributing to the event. Machine guarding that did not fully protect employees from moving machinery, ingoing nip points, rotating parts, and crushing hazards and not utilizing hazardous energy control procedures are factors that likely contributed to the event.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Prairie Du Chien site logged 21 recordable injuries or illnesses among about 520 workers: 4.0 per 100 full-time workers, against a median of 2.6 for its industry. Those cases cost 104 days away from work.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Prairie Du Chien site
Prairie Du Chien · 2025
520
21
7
4.0
2.6
Menomonie site
Menomonie · 2025
506
5
3
1.0
2.6
Wausau site
Wausau · 2023
200
3
2
1.5
2.1
Included with any plan: 23 more yearly logs from these sites, back to 2016, with each site's average rate over its latest three years. Already a subscriber? Sign in.
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 2 reports on file.
Jul 13, 2025, Menomonie: Hospitalization · multiple severe wounds and internal injuries · hand(s), finger(s) unspecified
At about 10:00 a.m. on July 13, 2025, an employee was cleaning the adhesive from running rollers using a rag soaked in cleaning solvent to prevent contamination. The rag was caught between two rollers and pulled the employee's right hand between the rollers. The employee sustained right hand crushing injuries, de-gloving injuries (palmer and dorsal sides), and fractures. The employee was…
On or about September 9, 2016, an employee was unrolling scrap film from one roll and placing it onto another roll when the edge of the roll slipped off the roller bearings. The employee and a coworker attempted to lift the roll approximately 1/16" back onto the roller bearings, but the roll shifted, pinching and amputating the meaty portion of the left middle finger between the roll and the cradle.
Wage and hour cases
Cases by the Labor Department's Wage and Hour Division since 2015: unpaid minimum wage or overtime, child labor, family leave and more.
Period reviewed
Violations
Workers owed
Back wages
Penalties
Sep 4, 2020 to Jul 13, 2021
Prairie du Chien
2
0
$0
$0
Sep 6, 2017 to Aug 4, 2018
Menomonie
2
1
$70,000
$0
The rules behind these citations
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
29 CFR 1904.2 · Partial exemption for establishments in certain industries
(c) Table Z-3. An employee's exposure to any substance listed in Table Z-3, in any 8-hour work shift of a 40-hour work week, shall not exceed the 8-hour time weighted average limit given for that substance in the table.
29 CFR 1910.1000(e)
(e) To achieve compliance with paragraphs (a) through (d) of this section, administrative or engineering controls must first be determined and implemented whenever feasible. When such controls are not feasible to achieve full compliance, protective equipment or any other protective measures shall be used to keep the exposure of employees to air contaminants within the limits prescribed in this section. Any equipment and/or technical measures used for this purpose must be approved for each particular use by a competent industrial hygienist or other technically qualified person. Whenever respirators are used, their use shall comply with 1910.134.
29 CFR 1910.120 · Hazardous waste operations and emergency response
29 CFR 1910.120(q)(1)
(1) A laminated, dated card or certificate with photo, denoting limitations and level of protection for which the employee is trained should be issued to those students successfully completing a course.
Alert subscribers get notified of each newly cited employer in Wisconsin the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.