Since 2013, OSHA inspectors have visited Aero Components, Inc. in Oklahoma 3 times.
The most recent inspection opened on Oct 26, 2021 as a planned inspection, in Oklahoma City.
In all, OSHA issued 6 citation items: 5 serious and 1 other-than-serious.
The proposed penalties came to $10,226; today they stand at $6,136, 40% less.
Among manufacturing employers, the typical cited inspection since 2015 ends with a $3,600 penalty. Aero Components, Inc. averages $3,994 across 1 cited inspection.
Aero Components, Inc. also files yearly injury logs with OSHA, summarized below.
It reported 1 severe injury to OSHA since 2015.
Citation items per year, by inspection date.
Oklahoma · latest 90 days of OSHA records
61employers cited
Get notified the morning OSHA posts each new citation in Oklahoma: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Oklahoma City site logged 0 recordable injuries or illnesses among about 90 workers: 0.0 per 100 full-time workers, against a median of 2.7 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Aero Components Inc
Oklahoma City · 2025
90
0
0
0.0
2.7
Aero Components Inc.
Oklahoma City · 2024
90
0
0
0.0
2.7
Severe injury reports
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 1 report on file.
An employee was operating a CNC machine. The employee was extracting used material when their left index finger was caught between two materials and amputated.
The rules behind these citations
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
(c) General—(1) Energy control program. The employer shall establish a program consisting of energy control procedures, employee training and periodic inspections to ensure that before any employee performs any servicing or maintenance on a machine or equipment where the unexpected energizing, start up or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source, and rendered inoperative.
(iii) Protection from arc welding rays. Where the work permits, the welder should be enclosed in an individual booth painted with a finish of low reflectivity such as zinc oxide (an important factor for absorbing ultraviolet radiations) and lamp black, or shall be enclosed with noncombustible screens similarly painted. Booths and screens shall permit circulation of air at floor level. Workers or other persons adjacent to the welding areas shall be protected from the rays by noncombustible or flameproof screens or shields or shall be required to wear appropriate goggles.
29 CFR 1910.303 · Electrical equipment, general requirements
29 CFR 1910.303(b)(2)
(2) Installation and use. Listed or labeled equipment shall be installed and used in accordance with any instructions included in the listing or labeling.
Alert subscribers get notified of each newly cited employer in Oklahoma the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.
