OSHA SearchOSHA records by employer

Celso Gonzalez: OSHA inspections and violations

Clemmons, North Carolina · Roofing Contractors · NAICS 238160

1inspections
4citation items
$3,900current penalties
Jun 11, 2019last inspection

Celso Gonzalez has one OSHA inspection on record in North Carolina.

OSHA opened it on Jun 11, 2019 as a planned inspection, in Clemmons.

From that inspection OSHA issued 4 citation items: 4 serious.

OSHA proposed $3,900 in penalties and the amount has not been reduced.

For context, across all construction employers the median penalty per cited inspection since 2015 is $3,079. Celso Gonzalez averages $3,900 over 1 cited inspection in that time.

Celso Gonzalez: OSHA citation items per year, 2019 to 2019
Citation items per year, by inspection date.

Want to know if OSHA cites Celso Gonzalez again? Add it to a watchlist and we will email you the morning the citation shows up.

Watch this company

Inspection history

Inspection 344074992 OPENED JUN 11, 2019Closed

Planned · Complete · Safety · 3 employees at the site · Closed Oct 24, 2024

404 Overlook Trail, Lot# 131, Clemmons, NC 27012 · Roofing Contractors · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1926.306(b)(3)(i) · Air receivers
 Serious$900$900Jun 17, 2019Final
Citation 1, item 2a
29 CFR 1926.501(b)(13) · Fall protection in construction
 Serious$1,500$1,500Jun 17, 2019Final
Citation 1, item 2b
29 CFR 1926.503(b)(1) · Fall protection training in construction
 Serious$0$0Jun 17, 2019Final
Citation 1, item 3
29 CFR 1926.1053(b)(1) · Ladders in construction
 Serious$1,500$1,500Jun 17, 2019Final

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1926.1053 · Ladders in construction

29 CFR 1926.1053(b)(1)

(1) When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.

29 CFR 1926.306 · Air receivers

29 CFR 1926.306(b)(3)(i)

(3) Gages and valves. (i) Every air receiver shall be equipped with an indicating pressure gage (so located as to be readily visible) and with one or more spring-loaded safety valves. The total relieving capacity of such safety valves shall be such as to prevent pressure in the receiver from exceeding the maximum allowable working pressure of the receiver by more than 10 percent.

29 CFR 1926.501 · Fall protection in construction

29 CFR 1926.501(b)(13)

(13) Residential construction. Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of § 1926.502.

29 CFR 1926.503 · Fall protection training in construction

Other roofing contractors employers in North Carolina

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.