OSHA inspectors have visited Mak Rak in Missouri one time.
It opened on Apr 26, 2022 on a referral, in Moberly.
In all, OSHA issued 1 citation item: 1 serious.
The penalties, $5,801 in total, stand where OSHA first set them.
Among manufacturing employers, the typical cited inspection since 2015 ends with a $3,600 penalty. Mak Rak averages $5,801 across 1 cited inspection.
It reported 1 severe injury to OSHA since 2015.
Want to know if OSHA cites Mak Rak again? Add it to a watchlist and we will email you the morning the citation shows up.
Watch this company100 Sparks Avenue, Moberly, MO 65270 · Sheet Metal Work Manufacturing · OSHA's record · Phone and website on Google Maps
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 29 CFR 1910.213(i)(1) · Woodworking machinery |
Serious | $5,801 | $5,801 | Sep 23, 2022 | Final |
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 1 report on file.
Apr 20, 2022, Moberly: Amputation · amputations · finger(s), fingernail(s), n.e.c.
An employee was cleaning a saw with a water hose. The handle of the hose caught in the sawblade and the employee's hand was drawn into the blade resulting in amputation of their right middle finger at the first knuckle.
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
29 CFR 1910.213(i)(1)
(i) Bandsaws and band resaws. (1) All portions of the saw blade shall be enclosed or guarded, except for the working portion of the blade between the bottom of the guide rolls and the table. Bandsaw wheels shall be fully encased. The outside periphery of the enclosure shall be solid. The front and back of the band wheels shall be either enclosed by solid material or by wire mesh or perforated metal. Such mesh or perforated metal shall be not less than 0.037 inch (U.S. Gage No. 20), and the openings shall be not greater than three-eighths inch. Solid material used for this purpose shall be of an equivalent strength and firmness. The guard for the portion of the blade between the sliding guide and the upper-saw-wheel guard shall protect the saw blade at the front and outer side. This portion of the guard shall be self-adjusting to raise and lower with the guide. The upper-wheel guard shall
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.