Northwest Stamping Inc: OSHA inspections and violations
Eugene, Oregon · Forging and Stamping · NAICS 332116
3inspections
4citation items
$2,275current penalties
Jan 31, 2024last inspection
Since 2009, OSHA inspectors have visited Northwest Stamping Inc in Oregon 3 times.
The most recent inspection opened on Jan 31, 2024 as a planned inspection, in Eugene.
In all, OSHA issued 4 citation items: 3 serious and 1 other-than-serious.
The penalties, $2,275 in total, stand where OSHA first set them.
Among manufacturing employers, the typical cited inspection since 2015 ends with a $3,600 penalty. Northwest Stamping Inc averages $1,088 across 2 cited inspections.
Northwest Stamping Inc also files yearly injury logs with OSHA, summarized below.
Citation items per year, by inspection date.
Oregon · latest 90 days of OSHA records
391employers cited
Get notified the morning OSHA posts each new citation in Oregon: the employer, the site address, the rules broken and the penalty.
Incident on Jan 19, 2018: Employee lacerates finger on band saw blade
At 11:30 a.m. on January 19, 2018, an employee was cutting a piece of metal (at a 45 degree angle with a block behind it) using a band saw. The piece of metal slipped and his right index finger came into contact with the blade, lacerating his finger. He was transported by Med-Express to the hospital for treatment. After about six hours in the Emergency Room, the surgeons scheduled surgery to put a pin in his finger. The employee stayed overnight in the hospital.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Eugene site logged 0 recordable injuries or illnesses among about 31 workers: 0.0 per 100 full-time workers, against a median of 4.0 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Northwest Stamping and Precision
Eugene · 2025
31
0
0
0.0
4.0
Included with any plan: 1 more yearly log from these sites, back to 2024, with each site's average rate over its latest three years. Already a subscriber? Sign in.
(ii) The point of operation of machines whose operation exposes an employee to injury, shall be guarded. The guarding device shall be in conformity with any appropriate standards therefor, or, in the absence of applicable specific standards, shall be so designed and constructed as to prevent the operator from having any part of his body in the danger zone during the operating cycle.
(9) Exposure adjustment. Safety guards of the types described in subparagraphs (3) and (4) of this paragraph, where the operator stands in front of the opening, shall be constructed so that the peripheral protecting member can be adjusted to the constantly decreasing diameter of the wheel. The maximum angular exposure above the horizontal plane of the wheel spindle as specified in paragraphs (b) (3) and (4) of this section shall never be exceeded, and the distance between the wheel periphery and the adjustable tongue or the end of the peripheral member at the top shall never exceed one-fourth inch. (See Figures O-18, O-19, O-20, O-21, O-22, and O-23.)
29 CFR 1910.303 · Electrical equipment, general requirements
29 CFR 1910.303(b)(2)
(2) Installation and use. Listed or labeled equipment shall be installed and used in accordance with any instructions included in the listing or labeling.
Alert subscribers get notified of each newly cited employer in Oregon the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.