Pillar Innovations has 2 OSHA inspections on record in New Mexico, the first in 2009.
OSHA's last visit started on Jul 19, 2017 as a planned inspection, in Farmington.
Across those inspections OSHA issued 5 citation items: 5 serious.
OSHA proposed $2,050 in penalties and the amount has not been reduced.
Most often, OSHA cited 1910.215, grinders and abrasive wheels (2 items).
For context, across all manufacturing employers the median penalty per cited inspection since 2015 is $3,600. Pillar Innovations averages $1,000 over 1 cited inspection in that time.
Pillar Innovations also files yearly injury logs with OSHA, summarized below.
Citation items per year, by inspection date.
New Mexico · latest 90 days of OSHA records
35employers cited
Get notified the morning OSHA posts each new citation in New Mexico: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Farmington site logged 0 recordable injuries or illnesses among about 21 workers: 0.0 per 100 full-time workers, against a median of 1.8 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Pillar Innovations, LLC - Farmington
Farmington · 2025
21
0
0
0.0
1.8
Included with any plan: 9 more yearly logs from these sites, back to 2016, with each site's average rate over its latest three years. Already a subscriber? Sign in.
(4) Work rests. On offhand grinding machines, work rests shall be used to support the work. They shall be of rigid construction and designed to be adjustable to compensate for wheel wear. Work rests shall be kept adjusted closely to the wheel with a maximum opening of one-eighth inch to prevent the work from being jammed between the wheel and the rest, which may cause wheel breakage. The work rest shall be securely clamped after each adjustment. The adjustment shall not be made with the wheel in motion.
29 CFR 1910.215(b)(9)
(9) Exposure adjustment. Safety guards of the types described in subparagraphs (3) and (4) of this paragraph, where the operator stands in front of the opening, shall be constructed so that the peripheral protecting member can be adjusted to the constantly decreasing diameter of the wheel. The maximum angular exposure above the horizontal plane of the wheel spindle as specified in paragraphs (b) (3) and (4) of this section shall never be exceeded, and the distance between the wheel periphery and the adjustable tongue or the end of the peripheral member at the top shall never exceed one-fourth inch. (See Figures O-18, O-19, O-20, O-21, O-22, and O-23.)
29 CFR 1910.219 · Belts, pulleys and power-transmission parts
29 CFR 1910.219(d)(1)
(d) Pulleys—(1) Guarding. Pulleys, any parts of which are seven (7) feet or less from the floor or working platform, shall be guarded in accordance with the standards specified in paragraphs (m) and (o) of this section. Pulleys serving as balance wheels (e.g., punch presses) on which the point of contact between belt and pulley is more than six feet six inches (6 ft. 6 in.) from the floor or platform may be guarded with a disk covering the spokes.
29 CFR 1910.29 · Fall protection systems in general industry
Other plate work manufacturing employers in New Mexico
Alert subscribers get notified of each newly cited employer in New Mexico the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.