Inspection 345439434 OPENED JUL 23, 2021Closed
Broadway And Lincoln, Escondido, CA 92026 · Electrical Contractors and Other Wiring Installation Contractors · OSHA's record · Phone and website on Google Maps
No citations from this inspection.
San Diego, California · Electrical Contractors and Other Wiring Installation Contractors · NAICS 238210
Since 1988, OSHA inspectors have visited Select Electric Inc in California 6 times.
The most recent inspection opened on Jul 23, 2021 after an accident, in Escondido.
In all, OSHA issued 12 citation items: 2 serious and 10 other-than-serious.
The proposed penalties came to $29,325; today they stand at $19,661, 33% less.
Among construction employers, the typical cited inspection since 2015 ends with a $3,080 penalty. Select Electric Inc averages $6,430 across 2 cited inspections.
California · latest 90 days of OSHA records
1,139employers cited
15 of them in the same industry
Get notified the morning OSHA posts each new citation in California: the employer, the site address, the rules broken and the penalty.
See who gets cited nextLatest cited in California
Checking a subcontractor, a client or your own company? Watch Select Electric Inc and get notified the morning OSHA posts a new citation for it.
Watch this companyBroadway And Lincoln, Escondido, CA 92026 · Electrical Contractors and Other Wiring Installation Contractors · OSHA's record · Phone and website on Google Maps
No citations from this inspection.
10 Freeway, West Covina, CA 91790 · Power and Communication Line and Related Structures Construction · OSHA's record · Phone and website on Google Maps
Incident on Jul 16, 2020: Employee falls when entangled with wire and innerduct and in
At 2:00 a.m. on July 16, 2020, an employee was pulling innerduct from subgrade electrical junction boxes using a work truck. The employee became entangled in wire and innerduct, which caused him to trip and fall to the ground. As a result of the fall, the employee struck his head on the ground and was subsequently dragged by the movement of the vehicle. The employee sustained a traumatic head injury and experienced hearing loss due to the accident. This incident underscores the hazards associated with working around vehicles and the importance of ensuring that work areas are clear and safe.
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 29 CFR 3203(A) |
Other-than-serious | $635 | $390 | Feb 26, 2021 | Final |
91 Frwy West Of Lincoln On-ramp, Corona, CA 92882 · Electrical Contractors and Other Wiring Installation Contractors · OSHA's record · Phone and website on Google Maps
Incident on Feb 4, 2017: Employee shocked when the crane contacts an overhead power l
At 2:30 p.m. on February 4, 2017, Employee #1 and coworker (crane operator) were tasked with hoisting/rigging operations involving the staging of metal and streetlight poles, on the ground next to their designated pole foundations until fully erected/mounted. While the (coworker) raised the boom of a [Manitowoc C-Series Crane], e.g., boom truck crane, Employee #1's (left foot) remained on the (rim) of the crane's rear wheel, and he then grabbed a metal, streetlight pole with his (right) hand. Afterwards, the hoisting cable (on the boom's topside), contacted high voltage power lines. Employee #1 then suffered immediate electrical shock, fell to the ground and lost consciousness. He sustained an entry wound (palm of hand proximal to right thumb) and an exit wound (topside side of his left big toe), each resulting in 3rd degree burns. Employee #1 was wearing standard PPE, e.g., hard hat, safety glasses, gloves, steel-toed boots, and a reflective class II vest. Employee #1 was trained in "hoisting and rigging operations", but not Overhead Power Line Procedures. Employee #1 was transported to the hospital, and then taken to Arrowhead Regional Medical Center. He was admitted and hospitalized for 1 day. for 1 day.
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 | Other-than-serious | $18,000 | $12,471 | Jul 25, 2017 | Final |
Spring St & Route 94, Spring Valley, CA 91979 · Electrical Contractors and Other Wiring Installation Contractors · OSHA's record · Phone and website on Google Maps
Incident on May 15, 2007: Employee's thumb is amputated by drill shaft
At approximately 12:30 p.m. on May 15, 2007, Employee #1 was working at a site n ear Spring Road and Route 94 in Spring Valley, CA. Also at the site were a cowor ker, who was a drill operator, and a foreman. All three employees were employed by a commercial contractor that specializes in street and traffic light installa tions in Southern California. Employee #1 was a locator, who walked on the groun d surface to locate the underground directional drill head using a detector unit to track the horizontal and angle movement of the drill head. This information was communicated back to the coworker, who was the operator seated on the direct ional boring machine (a Vermeer Number D24x40 Horizontal Directional Drill). The horizontal directional drill was used to dig under cement, pavement, and earth to lay electrical lines for street and traffic lights. The head of the drill fir st made a path through the soil underneath the ground, until it arrived at its d estination. A line was then pulled through it, so electrical lines could be inst alled to hookup traffic and signal lights for public streets and freeways. The f ront section of the horizontal directional boring machine was outfitted with a l eft and right anchor boring unit with stakes. The stakes were large auger units that tapped into the ground vertically to stabilize the machine when its drillin g rods apparently ran horizontally, underneath the ground. The bolt holding the auger bit to the shaft on the main frame of the directional boring machine came off, and the coworker had to take it apart to get to the dislodged bolt. Apparen tly, the coworker tightened the bolt, got up on the directional boring machine, seated himself, and unsuccessfully attempted to line up the square piece fitting of the shaft over the top of the auger attachment. Employee #1 came over and us ed his left hand to try and line up the shaft, while the coworker manipulated th e controls, in an attempt to attach the shaft to the auger bit. The shaft droppe d on employee's #1 left thumb, causing the top one inch to be amputated. The for eman transported Employee #1 to U.S. HealthWorks First and later transported him to the Orthopedic Center in La Jolla. Employee #1 was hospitalized and required outpatient surgery the day after the accident. The Division was notified about the accident on May 18, 2007. During the initial investigation, Employee #1 had not yet returned to work, but the Division found he had returned to work during a subsequent visit to another of the employer's job sites on June 11, 2007.
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 29 CFR 342 A |
Other-than-serious | $5,000 | $2,000 | Sep 6, 2007 | Final |
| Citation 1, item 2 29 CFR 1509 A |
Other-than-serious | $160 | $125 | Sep 6, 2007 | Closed |
| Citation 1, item 3 29 CFR 1509 B |
Other-than-serious | $160 | $125 | Sep 6, 2007 | Closed |
| Citation 1, item 5 29 CFR 1518 A |
Other-than-serious | $325 | $250 | Sep 6, 2007 | Closed |
| Citation 1, item 6 29 CFR 3314 G01 |
Other-than-serious | $160 | $125 | Sep 6, 2007 | Closed |
| Citation 1, item 7 29 CFR 3395 E03 |
Other-than-serious | $160 | $125 | Sep 6, 2007 | Closed |
| Citation 2, item 1 29 CFR 3314 C01 |
Serious | $2,925 | $2,250 | Sep 6, 2007 | Closed |
School House & San Elijo Rd, San Marcos, CA 92078 · Electrical Contractors and Other Wiring Installation Contractors · OSHA's record · Phone and website on Google Maps
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 29 CFR 3648 O |
Serious | $1,800 | $1,800 | Aug 20, 2004 | Closed |
I-5 From India To Grape, San Diego, CA 92124 · OSHA's record · Phone and website on Google Maps
| Citation and rule | Type | Proposed | Current | Issued | Status |
|---|---|---|---|---|---|
| Citation 1, item 1 29 CFR 1926.152(a)(1) · Flammable liquids |
Other-than-serious | $0 | $0 | Nov 10, 1988 | Closed |
| Citation 1, item 2 29 CFR 1926.150(a)(4) · Fire protection |
Other-than-serious | $0 | $0 | Nov 10, 1988 | Closed |
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
29 CFR 1926.150(a)(4)
(4) All firefighting equipment shall be periodically inspected and maintained in operating condition. Defective equipment shall be immediately replaced.
29 CFR 1926.152(a)(1)
(a) General requirements. (1) Only approved containers and portable tanks shall be used for storage and handling of flammable liquids. Approved safety cans or Department of Transportation approved containers shall be used for the handling and use of flammable liquids in quantities of 5 gallons or less, except that this shall not apply to those flammable liquid materials which are highly viscid (extremely hard to pour), which may be used and handled in original shipping containers. For quantities of one gallon or less, the original container may be used, for storage, use and handling of flammable liquids.
Alert subscribers get notified of each newly cited employer in California the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.