OSHA SearchOSHA records by employer

Serio Construction: OSHA inspections and violations

Eden, Utah · Framing Contractors · NAICS 238130

2inspections
3citation items
$750current penalties
Apr 8, 2019last inspection

Since 1999, OSHA inspectors have visited Serio Construction in Utah 2 times.

The most recent inspection opened on Apr 8, 2019 as a planned inspection, in Eden.

In all, OSHA issued 3 citation items: 1 serious and 2 other-than-serious.

The proposed penalties came to $1,500; today they stand at $750, 50% less.

Among construction employers, the typical cited inspection since 2015 ends with a $3,078 penalty. Serio Construction averages $750 across 1 cited inspection.

Serio Construction: OSHA citation items per year, 1999 to 2019
Citation items per year, by inspection date.

Want to know if OSHA cites Serio Construction again? Add it to a watchlist and we will email you the morning the citation shows up.

Watch this company

Inspection history

Inspection 343916987 OPENED APR 8, 2019Closed

Planned · Partial · Safety · 5 employees at the site · Closed May 10, 2019

Vicinity Of 5938 E Bighorn Parkway, Eden, UT 84310 · Framing Contractors · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1926.1053(b)(1) · Ladders in construction
Serious$1,500$750Apr 18, 2019Final

Inspection 126800242 OPENED MAR 18, 1999Closed

Planned · Complete · Safety · 8 employees at the site · Closed Dec 5, 2003

Wolf Creek-trend West Resorts, Eden, UT 84310 · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1926.405(j)(4)(iva) · Job-site wiring
Other-than-serious$0$0Mar 30, 1999Closed
Citation 1, item 2
29 CFR 1926.501(b)(13) · Fall protection in construction
Other-than-serious$0$0Mar 30, 1999Closed

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1926.1053 · Ladders in construction

29 CFR 1926.1053(b)(1)

(1) When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.

29 CFR 1926.405 · Job-site wiring

29 CFR 1926.405(j)(4)(iva)

(iv) Protection of live parts—all voltages. (A) Stationary motors having commutators, collectors, and brush rigging located inside of motor end brackets and not conductively connected to supply circuits operating at more than 150 volts to ground need not have such parts guarded. Exposed live parts of motors and controllers operating at 50 volts or more between terminals shall be guarded against accidental contact by any of the following:

29 CFR 1926.501 · Fall protection in construction

29 CFR 1926.501(b)(13)

(13) Residential construction. Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of § 1926.502.

Other framing contractors employers in Utah

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.