OSHA SearchOSHA records by employer

Wayne Mello: OSHA inspections and violations

Tilton, New Hampshire · Painting and Wall Covering Contractors · NAICS 238320

1inspections
5citation items
$3,259current penalties
Aug 17, 2017last inspection

OSHA inspectors have visited Wayne Mello in New Hampshire one time.

It opened on Aug 17, 2017 as a planned inspection, in Tilton.

In all, OSHA issued 5 citation items: 4 serious and 1 other-than-serious.

The proposed penalties came to $9,235; today they stand at $3,259, 65% less.

Among construction employers, the typical cited inspection since 2015 ends with a $3,079 penalty. Wayne Mello averages $3,259 across 1 cited inspection.

Wayne Mello: OSHA citation items per year, 2017 to 2017
Citation items per year, by inspection date.

Want to know if OSHA cites Wayne Mello again? Add it to a watchlist and we will email you the morning the citation shows up.

Watch this company

Inspection history

Inspection 342560810 OPENED AUG 17, 2017Closed

Planned · Partial · Safety · 2 employees at the site · Closed Apr 4, 2018

75 Laconia Road, Tilton, NH 03276 · Painting and Wall Covering Contractors · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1a
29 CFR 1926.454(a) · Scaffold training
 Serious$2,716$1,358Oct 26, 2017Final
Citation 1, item 1b
29 CFR 1926.503(a)(1) · Fall protection training in construction
 Serious$0$0Oct 26, 2017Final
Citation 1, item 2a
29 CFR 1926.501(b)(11) · Fall protection in construction
 Serious$3,803$1,901Oct 26, 2017Final
Citation 1, item 2b
29 CFR 1926.1051(a) · Stairways and Ladders: general requirements
 Serious$2,716$0Oct 26, 2017Final
Citation 2, item 1
29 CFR 1926.404(b)(1)(ii) · Ground-fault protection on job sites
 Other-than-serious$0$0Oct 26, 2017Final

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1926.1051 · Stairways and Ladders: general requirements

29 CFR 1926.1051(a)

(a) A stairway or ladder shall be provided at all personnel points of access where there is a break in elevation of 19 inches (48 cm) or more, and no ramp, runway, sloped embankment, or personnel hoist is provided.

29 CFR 1926.404 · Ground-fault protection on job sites

29 CFR 1926.404(b)(1)(ii)

(ii) Ground-fault circuit interrupters. All 120-volt, single-phase, 15- and 20-ampere receptacle outlets on construction sites, which are not a part of the permanent wiring of the building or structure and which are in use by employees, shall have approved ground-fault circuit interrupters for personnel protection. Receptacles on a two-wire, single-phase portable or vehicle-mounted generator rated not more than 5kW, where the circuit conductors of the generator are insulated from the generator frame and all other grounded surfaces, need not be protected with ground-fault circuit interrupters.

29 CFR 1926.454 · Scaffold training

29 CFR 1926.454(a)

(a) The employer shall have each employee who performs work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards. The training shall include the following areas, as applicable:

29 CFR 1926.501 · Fall protection in construction

29 CFR 1926.503 · Fall protection training in construction

Other painting and wall covering contractors employers in New Hampshire

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.