Terrell, Texas · Secondary Smelting, Refining, and Alloying of Nonferrous Metal (except Copper and Aluminum) · NAICS 331492
5inspections
11citation items
$37,575current penalties
Jan 7, 2019last inspection
OSHA has inspected Conecsus, LLC 5 times in Texas since 2012.
The latest one began on Jan 7, 2019 to follow up on an earlier case, in Terrell.
Those inspections ended with 11 citation items: 5 serious, 2 repeat and 4 other-than-serious.
Penalties were first proposed at $46,975 and now stand at $37,575, 20% lower after settlements or reviews.
Lead in general industry comes up most often in these citations: 4 items under 1910.1025.
How that compares: the median penalty per cited inspection for manufacturing employers since 2015 is $3,600, and Conecsus, LLC averages $24,575 (1 cited inspection).
Conecsus, LLC also files yearly injury logs with OSHA, summarized below.
It reported 2 severe injuries to OSHA since 2015.
Citation items per year, by inspection date.
Want to know if OSHA cites Conecsus, LLC again? Add it to a watchlist and we will email you the morning the citation shows up.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2023, the Terrell site logged 2 recordable injuries or illnesses among about 48 workers: 7.7 per 100 full-time workers, against a median of 2.9 for its industry. Those cases cost 1 days away from work.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Conecsus LLC
Terrell · 2023
48
2
1
7.7
2.9
Conecsus LLC
Terrell · 2022
43
2
1
3.9
2.9
Conecsus Tejas
Terrell · 2021
36
0
0
0.0
2.9
Conecsus Aerospace
Terrell · 2019
30
0
0
0.0
2.3
Severe injury reports
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 2 reports on file.
Dec 4, 2020, Terrell: Hospitalization · fractures · wrist(s)
An employee slipped and fell to the ground. The employee was hospitalized with fractures to both wrists.
(ii) If the initial monitoring, required by this section, or subsequent monitoring reveals employee exposure to be above the permissible exposure limit, the employer shall repeat monitoring at least quarterly.
29 CFR 1910.1018(g)(1)(i)
(g) Methods of compliance—(1) Controls. (i) The employer shall institute at the earliest possible time but not later than December 31, 1979, engineering and work practice controls to reduce exposures to or below the permissible exposure limit, except to the extent that the employer can establish that such controls are not feasible.
(iii) If the initial monitoring reveals that employee exposure is above the permissible exposure limit the employer shall repeat monitoring quarterly. The employer shall continue monitoring at the required frequency until at least two consecutive measurements, taken at least 7 days apart, are below the PEL but at or above the action level at which time the employer shall repeat monitoring for that employee at the frequency specified in paragraph (d)(6)(ii), except as otherwise provided in paragraph (d)(7) of this section.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.