OSHA has inspected Custom Fixtures Inc once in Nebraska.
The inspection began on Mar 9, 2018 as a planned inspection, in Beatrice.
That inspection ended with 6 citation items: 4 serious and 2 other-than-serious.
Penalties were first proposed at $21,988 and now stand at $13,200, 40% lower after settlements or reviews.
Woodworking machinery comes up most often in these citations: 3 items under 1910.213.
How that compares: the median penalty per cited inspection for manufacturing employers since 2015 is $3,600, and Custom Fixtures Inc averages $13,200 (1 cited inspection).
Custom Fixtures Inc also files yearly injury logs with OSHA, summarized below.
Citation items per year, by inspection date.
Nebraska · latest 90 days of OSHA records
30employers cited
Get notified the morning OSHA posts each new citation in Nebraska: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Beatrice site logged 9 recordable injuries or illnesses among about 56 workers: 15.5 per 100 full-time workers, against a median of 3.7 for its industry. Those cases cost 3 days away from work.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Main Office
Beatrice · 2025
56
9
2
15.5
3.7
Custom Fixtures, Inc.
Beatrice · 2017
49
0
0
0.0
3.7
The rules behind these citations
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
(a) Machine guarding—(1) Types of guarding. One or more methods of machine guarding shall be provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks. Examples of guarding methods are—barrier guards, two-hand tripping devices, electronic safety devices, etc.
(2) Each hand-fed circular ripsaw shall be furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator. The spreader shall be made of hard tempered steel, or its equivalent, and shall be thinner than the saw kerf. It shall be of sufficient width to provide adequate stiffness or rigidity to resist any reasonable side thrust or blow tending to bend or throw it out of position. The spreader shall be attached so that it will remain in true alignment with the saw even when either the saw or table is tilted. The provision of a spreader in connection with grooving, dadoing, or rabbeting is not required. On the completion of such operations, the spreader shall be immediately replaced.
29 CFR 1910.213(c)(3)
(3) Each hand-fed circular ripsaw shall be provided with nonkickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator. They shall be designed to provide adequate holding power for all the thicknesses of materials being cut.
29 CFR 1910.303 · Electrical equipment, general requirements
Alert subscribers get notified of each newly cited employer in Nebraska the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.