Eastern Sheet Metal, Inc.: OSHA inspections and violations
Dothan, Alabama · Sheet Metal Work Manufacturing · NAICS 332322
3inspections
7citation items
$17,390current penalties
Dec 16, 2020last inspection
Since 2015, OSHA inspectors have visited Eastern Sheet Metal, Inc. in Alabama 3 times.
The most recent inspection opened on Dec 16, 2020 as a planned inspection, in Dothan.
In all, OSHA issued 7 citation items: 4 serious and 3 other-than-serious.
The proposed penalties came to $25,419; today they stand at $17,390, 32% less.
The rule cited most here is 1910.212 (machine guarding), 3 times.
Among manufacturing employers, the typical cited inspection since 2015 ends with a $3,600 penalty. Eastern Sheet Metal, Inc. averages $5,797 across 3 cited inspections.
Eastern Sheet Metal, Inc. also files yearly injury logs with OSHA, summarized below.
It reported 1 severe injury to OSHA since 2015.
Citation items per year, by inspection date.
Alabama · latest 90 days of OSHA records
99employers cited
Get notified the morning OSHA posts each new citation in Alabama: the employer, the site address, the rules broken and the penalty.
Incident on Apr 20, 2021: Employee partially amputates finger between die and metal
At 10:30 a.m. on April 20, 2021, an employee working as a machine operator for a sheet metal manufacturer was working at the Transverse Duct Flange (TDF) machine straightening metal parts while finishing a production run. The employee reached his hand into the space between the exit shot and die to remove built up metal shavings. The employee's hand was caught between the die and a metal flange part. The employee was hospitalized to treat an amputation to his left index finger from the knuckle to the fingertip.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2017, the Dothan site logged 9 recordable injuries or illnesses among about 85 workers: 9.0 per 100 full-time workers, against a median of 3.6 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Eastern Sheet Metal
Dothan · 2017
85
9
0
9.0
3.6
Severe injury reports
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 1 report on file.
(a) General requirements. (1) The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.
(3) Machine or equipment isolation. All energy isolating devices that are needed to control the energy to the machine or equipment shall be physically located and operated in such a manner as to isolate the machine or equipment from the energy source(s).
29 CFR 1910.147(f)(3)(ii)
(ii) Group lockout or tagout devices shall be used in accordance with the procedures required by paragraph (c)(4) of this section including, but not necessarily limited to, the following specific requirements:
Alert subscribers get notified of each newly cited employer in Alabama the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.