Edge Manufacturing Inc: OSHA inspections and violations
Bluffton, Indiana · Fabricated Structural Metal Manufacturing · NAICS 332312
1inspections
3citation items
$1,625current penalties
Oct 22, 2020last inspection
OSHA inspectors have visited Edge Manufacturing Inc in Indiana one time.
It opened on Oct 22, 2020 on a referral, in Bluffton.
In all, OSHA issued 3 citation items: 3 serious.
The proposed penalties came to $2,500; today they stand at $1,625, 35% less.
The rule cited most here is 1910.333 (working near live electrical parts), 2 times.
Among manufacturing employers, the typical cited inspection since 2015 ends with a $3,600 penalty. Edge Manufacturing Inc averages $1,625 across 1 cited inspection.
Edge Manufacturing Inc also files yearly injury logs with OSHA, summarized below.
Citation items per year, by inspection date.
Indiana · latest 90 days of OSHA records
78employers cited
Get notified the morning OSHA posts each new citation in Indiana: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Bluffton site logged 0 recordable injuries or illnesses among about 60 workers: 0.0 per 100 full-time workers, against a median of 2.6 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Edge Manufacturing, Inc.
Bluffton · 2025
60
0
0
0.0
2.6
Included with any plan: 9 more yearly logs from these sites, back to 2016, with each site's average rate over its latest three years. Already a subscriber? Sign in.
(b) Content of training—(1) Practices addressed in this standard. Employees shall be trained in and familiar with the safety-related work practices required by §§ 1910.331 through 1910.335 that pertain to their respective job assignments.
(1) Deenergized parts. Live parts to which an employee may be exposed shall be deenergized before the employee works on or near them, unless the employer can demonstrate that deenergizing introduces additional or increased hazards or is infeasible due to equipment design or operational limitations. Live parts that operate at less than 50 volts to ground need not be deenergized if there will be no increased exposure to electrical burns or to explosion due to electric arcs.
29 CFR 1910.333(a)(2)
(2) Energized parts. If the exposed live parts are not deenergized (i.e., for reasons of increased or additional hazards or infeasibility), other safety-related work practices shall be used to protect employees who may be exposed to the electrical hazards involved. Such work practices shall protect employees against contact with energized circuit parts directly with any part of their body or indirectly through some other conductive object. The work practices that are used shall be suitable for the conditions under which the work is to be performed and for the voltage level of the exposed electric conductors or circuit parts. Specific work practice requirements are detailed in paragraph (c) of this section.
Other fabricated structural metal manufacturing employers in Indiana
Alert subscribers get notified of each newly cited employer in Indiana the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.