OSHA SearchOSHA records by employer

Jorge Robilson: OSHA inspections and violations

Fairhope, Alabama · Framing Contractors · NAICS 238130

1inspections
3citation items
$4,546current penalties
May 23, 2019last inspection

OSHA inspectors have visited Jorge Robilson in Alabama one time.

It opened on May 23, 2019 as a planned inspection, in Fairhope.

In all, OSHA issued 3 citation items: 3 serious.

The penalties, $4,546 in total, stand where OSHA first set them.

The rule cited most here is 1926.1053 (ladders in construction), 2 times.

Among construction employers, the typical cited inspection since 2015 ends with a $3,079 penalty. Jorge Robilson averages $4,546 across 1 cited inspection.

Jorge Robilson: OSHA citation items per year, 2019 to 2019
Citation items per year, by inspection date.

Want to know if OSHA cites Jorge Robilson again? Add it to a watchlist and we will email you the morning the citation shows up.

Watch this company

Inspection history

Inspection 344030952 OPENED MAY 23, 2019Closed

Planned · Partial · Safety · 5 employees at the site · Closed Nov 30, 2022

10929 Naples Ave. Lot 100 The Verandas, Fairhope, AL 36532 · Framing Contractors · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1926.501(b)(13) · Fall protection in construction
 Serious$2,273$2,273Jun 3, 2019Final
Citation 1, item 2a
29 CFR 1926.1053(a)(1)(i) · Ladders in construction
 Serious$2,273$2,273Jun 3, 2019Final
Citation 1, item 2b
29 CFR 1926.1053(b)(1) · Ladders in construction
 Serious$0$0Jun 3, 2019Final

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1926.1053 · Ladders in construction

29 CFR 1926.1053(a)(1)(i)

(i) Each self-supporting portable ladder: At least four times the maximum intended load, except that each extra-heavy-duty type 1A metal or plastic ladder shall sustain at least 3.3 times the maximum intended load. The ability of a ladder to sustain the loads indicated in this paragraph shall be determined by applying or transmitting the requisite load to the ladder in a downward vertical direction. Ladders built and tested in conformance with the applicable provisions of appendix A of this subpart will be deemed to meet this requirement.

29 CFR 1926.1053(b)(1)

(1) When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support.

29 CFR 1926.501 · Fall protection in construction

29 CFR 1926.501(b)(13)

(13) Residential construction. Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of § 1926.502.

Other framing contractors employers in Alabama

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.