OSHA SearchOSHA records by employer

Mario Chavez: OSHA inspections and violations

Fairhope, Alabama · Framing Contractors · NAICS 238130

1inspections
5citation items
$7,378current penalties
Nov 13, 2025last inspection

OSHA inspectors have visited Mario Chavez in Alabama one time.

It opened on Nov 13, 2025 as a planned inspection, in Fairhope and is still open.

In all, OSHA issued 5 citation items: 5 serious.

The penalties, $7,378 in total, stand where OSHA first set them.

The rule cited most here is 1926.451 (scaffolds, general requirements), 2 times.

Among construction employers, the typical cited inspection since 2015 ends with a $3,080 penalty. Mario Chavez averages $7,378 across 1 cited inspection.

Mario Chavez: OSHA citation items per year, 2025 to 2025
Citation items per year, by inspection date.

Want to know if OSHA cites Mario Chavez again? Add it to a watchlist and we will email you the morning the citation shows up.

Watch this company

Inspection history

Inspection 348591470 OPENED NOV 13, 2025Open

Planned · Partial · Safety · 6 employees at the site · Open

156 Mount Pleasant Bouelvard Lot 33 North Hills At Fairhope, Fairhope, AL 36532 · Framing Contractors · OSHA's record · Phone and website on Google Maps

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1926.102(a)(1) · Eye and face protection in construction
 Serious$2,270$2,270Dec 9, 2025Final
Citation 1, item 2a
29 CFR 1926.451(b)(1)(i) · Scaffolds, general requirements
 Serious$2,838$2,838Dec 9, 2025Final
Citation 1, item 2b
29 CFR 1926.451(g)(1) · Scaffolds, general requirements
 Serious$0$0Dec 9, 2025Final
Citation 1, item 2c
29 CFR 1926.454(a) · Scaffold training
 Serious$0$0Dec 9, 2025Final
Citation 1, item 3
29 CFR 1926.501(b)(13) · Fall protection in construction
 Serious$2,270$2,270Dec 9, 2025Final

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1926.102 · Eye and face protection in construction

29 CFR 1926.102(a)(1)

(a) General. (1) The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.

29 CFR 1926.451 · Scaffolds, general requirements

29 CFR 1926.451(b)(1)(i)

(i) Each platform unit (e.g., scaffold plank, fabricated plank, fabricated deck, or fabricated platform) shall be installed so that the space between adjacent units and the space between the platform and the uprights is no more than 1 inch (2.5 cm) wide, except where the employer can demonstrate that a wider space is necessary (for example, to fit around uprights when side brackets are used to extend the width of the platform).

29 CFR 1926.451(g)(1)

(g) Fall protection. (1) Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1) (i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. Paragraph (g)(2) of this section addresses fall protection for scaffold erectors and dismantlers.

29 CFR 1926.454 · Scaffold training

29 CFR 1926.501 · Fall protection in construction

Other framing contractors employers in Alabama

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.