OSHA has inspected Recline Design Inc. once in Mississippi.
The inspection began on Jun 8, 2022 on a referral, in Pontotoc.
That inspection ended with 2 citation items: 2 serious.
Penalties were first proposed at $21,132 and now stand at $12,679, 40% lower after settlements or reviews.
How that compares: the median penalty per cited inspection for manufacturing employers since 2015 is $3,600, and Recline Design Inc. averages $12,679 (1 cited inspection).
Recline Design Inc. also files yearly injury logs with OSHA, summarized below.
It reported 1 severe injury to OSHA since 2015.
Citation items per year, by inspection date.
Mississippi · latest 90 days of OSHA records
15employers cited
Get notified the morning OSHA posts each new citation in Mississippi: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2024, the Pontotoc site logged 0 recordable injuries or illnesses among about 51 workers: 0.0 per 100 full-time workers, against a median of 3.3 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Recline Design
Pontotoc · 2024
51
0
0
0.0
3.3
Included with any plan: 5 more yearly logs from these sites, back to 2019, with each site's average rate over its latest three years. Already a subscriber? Sign in.
Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 1 report on file.
Jun 1, 2022, Pontotoc: Hospitalization · internal injuries to organs and blood vessels of the trunk · abdomen, except internal location of diseases or disorders
An employee was feeding wood into a ripsaw. The saw kicked back and a small board struck the employee's abdomen, causing internal injuries.
The rules behind these citations
Current text from the Code of Federal Regulations. Some citations were issued under older wording.
(2) Each hand-fed circular ripsaw shall be furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator. The spreader shall be made of hard tempered steel, or its equivalent, and shall be thinner than the saw kerf. It shall be of sufficient width to provide adequate stiffness or rigidity to resist any reasonable side thrust or blow tending to bend or throw it out of position. The spreader shall be attached so that it will remain in true alignment with the saw even when either the saw or table is tilted. The provision of a spreader in connection with grooving, dadoing, or rabbeting is not required. On the completion of such operations, the spreader shall be immediately replaced.
Each employer shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees.
Other upholstered household furniture manufacturing employers in Mississippi
Alert subscribers get notified of each newly cited employer in Mississippi the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.