OSHA SearchOSHA records by employer

BP Wind Energy NA: OSHA inspections and violations

Fort Stockton, Texas · Wind Electric Power Generation · NAICS 221115

1inspections
4citation items
$27,704current penalties
Jan 19, 2017last inspection

OSHA inspectors have visited BP Wind Energy NA in Texas one time.

It opened on Jan 19, 2017 on a referral, in Fort Stockton.

In all, OSHA issued 4 citation items: 4 serious.

The penalties, $27,704 in total, stand where OSHA first set them.

The rule cited most here is 1910.333 (working near live electrical parts), 3 times.

Among utility employers, the typical cited inspection since 2015 ends with a $0 penalty. BP Wind Energy NA averages $27,704 across 1 cited inspection.

It reported 1 severe injury to OSHA since 2015.

BP Wind Energy NA: OSHA citation items per year, 2017 to 2017
Citation items per year, by inspection date.

Texas · latest 90 days of OSHA records

391employers cited

Get notified the morning OSHA posts each new citation in Texas: the employer, the site address, the rules broken and the penalty.

See who gets cited next

Latest cited in Texas

Checking a subcontractor, a client or your own company? Watch BP Wind Energy NA and get notified the morning OSHA posts a new citation for it.

Watch this company

Inspection history

Inspection 342041274 OPENED JAN 19, 2017Closed

Referral · Partial · Safety · 500 employees at the site · Closed Aug 7, 2017

5697 Trans Pecos Rd, Fort Stockton, TX 79735 · Wind Electric Power Generation · OSHA's record · Phone and website on Google Maps

Incident on Jan 13, 2017: Two employee receive injuries when an arc flash occurs

At 2:15 p.m., Employee #1 and Employee #2 were performing pre-job planning for work to be done at a later date. Employee #1 opened the electrical box and an arc flash occurred. Employees suffered burns.

Citation and ruleTypeProposedCurrentIssuedStatus
Citation 1, item 1
29 CFR 1910.269(a)(3)(i)(c) · Electric power generation, transmission, and distribution
Serious$6,926$6,926Jun 19, 2017Final
Citation 1, item 2
29 CFR 1910.333(a)(1) · Working near live electrical parts
Serious$6,926$6,926Jun 19, 2017Final
Citation 1, item 3
29 CFR 1910.333(b)(2)(ii)(b) · Working near live electrical parts
Serious$6,926$6,926Jun 19, 2017Final
Citation 1, item 4
29 CFR 1910.333(b)(2)(iv) · Working near live electrical parts
Serious$6,926$6,926Jun 19, 2017Final

Severe injury reports

Employers must report any work-related amputation, in-patient hospitalization or loss of an eye to OSHA within 24 hours. 1 report on file.

Jan 13, 2017, Fort Stockton: Hospitalization · electrical burns, unspecified · face, unspecified

A BP employee and two contractor employees were conducting a pre-job assessment at the electrical sub-station when an electrical arc flash occurred from an electrical box, injuring all three employees. The BP employee suffered facial burns.

The rules behind these citations

Current text from the Code of Federal Regulations. Some citations were issued under older wording.

29 CFR 1910.269 · Electric power generation, transmission, and distribution

29 CFR 1910.269(a)(3)(i)(c)

(C) Information about the design and operation of the host employer's installation that the contract employer needs to make the assessments required by this section; and

29 CFR 1910.333 · Working near live electrical parts

29 CFR 1910.333(a)(1)

(1) Deenergized parts. Live parts to which an employee may be exposed shall be deenergized before the employee works on or near them, unless the employer can demonstrate that deenergizing introduces additional or increased hazards or is infeasible due to equipment design or operational limitations. Live parts that operate at less than 50 volts to ground need not be deenergized if there will be no increased exposure to electrical burns or to explosion due to electric arcs.

29 CFR 1910.333(b)(2)(ii)(b)

(B) The circuits and equipment to be worked on shall be disconnected from all electric energy sources. Control circuit devices, such as push buttons, selector switches, and interlocks, may not be used as the sole means for deenergizing circuits or equipment. Interlocks for electric equipment may not be used as a substitute for lockout and tagging procedures.

Other wind electric power generation employers in Texas

Alert subscribers get notified of each newly cited employer in Texas the morning it is posted. See the alert plans.

Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.