Fort Payne, Alabama · Other Motor Vehicle Parts Manufacturing · NAICS 336390
2inspections
6citation items
$9,375current penalties
Jul 15, 2015last inspection
OSHA has inspected Plasman Corp LLC 2 times in Alabama since 2014.
The latest one began on Jul 15, 2015 after a complaint, in Fort Payne.
Those inspections ended with 6 citation items: 5 serious and 1 other-than-serious.
Penalties were first proposed at $15,625 and now stand at $9,375, 40% lower after settlements or reviews.
Grinders and abrasive wheels comes up most often in these citations: 2 items under 1910.215.
How that compares: the median penalty per cited inspection for manufacturing employers since 2015 is $3,600, and Plasman Corp LLC averages $5,730 (1 cited inspection).
Plasman Corp LLC also files yearly injury logs with OSHA, summarized below.
Citation items per year, by inspection date.
Alabama · latest 90 days of OSHA records
100employers cited
2 of them in the same industry
Get notified the morning OSHA posts each new citation in Alabama: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Fort Payne site logged 6 recordable injuries or illnesses among about 350 workers: 1.3 per 100 full-time workers, against a median of 2.7 for its industry. Those cases cost 201 days away from work.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Plasman
Fort Payne · 2025
350
6
4
1.3
2.7
Included with any plan: 3 more yearly logs from these sites, back to 2020, with each site's average rate over its latest three years. Already a subscriber? Sign in.
(a) Machine guarding—(1) Types of guarding. One or more methods of machine guarding shall be provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks. Examples of guarding methods are—barrier guards, two-hand tripping devices, electronic safety devices, etc.
(4) Work rests. On offhand grinding machines, work rests shall be used to support the work. They shall be of rigid construction and designed to be adjustable to compensate for wheel wear. Work rests shall be kept adjusted closely to the wheel with a maximum opening of one-eighth inch to prevent the work from being jammed between the wheel and the rest, which may cause wheel breakage. The work rest shall be securely clamped after each adjustment. The adjustment shall not be made with the wheel in motion.
29 CFR 1910.215(b)(9)
(9) Exposure adjustment. Safety guards of the types described in subparagraphs (3) and (4) of this paragraph, where the operator stands in front of the opening, shall be constructed so that the peripheral protecting member can be adjusted to the constantly decreasing diameter of the wheel. The maximum angular exposure above the horizontal plane of the wheel spindle as specified in paragraphs (b) (3) and (4) of this section shall never be exceeded, and the distance between the wheel periphery and the adjustable tongue or the end of the peripheral member at the top shall never exceed one-fourth inch. (See Figures O-18, O-19, O-20, O-21, O-22, and O-23.)
29 CFR 1910.303 · Electrical equipment, general requirements
Alert subscribers get notified of each newly cited employer in Alabama the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.