Upper Sandusky, Ohio · Rubber Product Manufacturing for Mechanical Use · NAICS 326291
11inspections
50citation items
$43,718current penalties
Jul 23, 2018last inspection
Uni-Grip, Inc. has 11 OSHA inspections on record in Ohio, the first in 1973.
OSHA's last visit started on Jul 23, 2018 on a referral, in Upper Sandusky.
Across those inspections OSHA issued 50 citation items: 20 serious, 1 repeat and 29 other-than-serious.
OSHA proposed $71,627 in penalties. After settlements and reviews the total is $43,718, down 39%.
Most often, OSHA cited 1910.212, machine guarding (8 items).
For context, across all manufacturing employers the median penalty per cited inspection since 2015 is $4,500. Uni-Grip, Inc. averages $20,015 over 2 cited inspections in that time.
Uni-Grip, Inc. also files yearly injury logs with OSHA, summarized below.
It reported 2 severe injuries to OSHA since 2015.
Citation items per year, by inspection date.
Ohio · latest 90 days of OSHA records
267employers cited
2 of them in the same industry
Get notified the morning OSHA posts each new citation in Ohio: the employer, the site address, the rules broken and the penalty.
Incident on Jul 16, 2018: Employee partially amputates finger while using puller-cutte
At 2:30 a.m. on July 16, 2018, an employee was operating a Extrusion Services, Inc. Catapuller Puller-Cutter Machine and attempted to reach for short piece of stock where a cutting knife is located. The employee sustained a partial finger amputation to the end of the left middle finger when he came into contact with cutting knife and was hospitalized.
Incident on Sep 21, 2017: Employee sustains partial amputation of finger while operati
At 7:15 a.m. on September 21, 2017, Employee #1 was operating the hole puncher machine. The machine was built in-house and had eight sections, which are located next to each other. There are seven hole punching sections on the right side of the machine and one guillotine section on the left side of the machine. The employee was using the guillotine section to cut the product to the correct length. The machine is activated by two thumb control buttons. The control buttons are located in close proximity to the machine's point of operation so that the employees are able to activate the machine with one hand while holding the product/material with the other hand. The employee was holding the product with his right hand, and when he activated the machine, one of the punches came down on his right pinky, resulting in a partial amputation of the finger. amputation of the finger.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2025, the Upper Sandusky site logged 5 recordable injuries or illnesses among about 75 workers: 6.7 per 100 full-time workers, against a median of 2.9 for its industry.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Uni-Grip, Inc.
Upper Sandusky · 2025
75
5
0
6.7
2.9
Included with any plan: 7 more yearly logs from these sites, back to 2016, with each site's average rate over its latest three years. Already a subscriber? Sign in.
On July 16, 2018, an employee was using an auto cutter when a part became jammed in the cutting hole. As he attempted to clear the jam, the cutting mechanism cut his left middle fingertip, resulting in a partial amputation. The machine was running and guarded at the time of the incident.
(a) Basic requirement. You must consider an injury or illness to be work-related if an event or exposure in the work environment either caused or contributed to the resulting condition or significantly aggravated a pre-existing injury or illness. Work-relatedness is presumed for injuries and illnesses resulting from events or exposures occurring in the work environment, unless an exception in § 1904.5(b)(2) specifically applies.
(f) Hepatitis B vaccination and post-exposure evaluation and follow-up—(1) General. (i) The employer shall make available the hepatitis B vaccine and vaccination series to all employees who have occupational exposure, and post-exposure evaluation and follow-up to all employees who have had an exposure incident.
(e) Written hazard communication program. (1) Employers shall develop, implement, and maintain at each workplace, a written hazard communication program which at least describes how the criteria specified in paragraphs (f), (g), and (h) of this section for labels and other forms of warning, safety data sheets, and employee information and training will be met, and which also includes the following:
Alert subscribers get notified of each newly cited employer in Ohio the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.