OSHA has inspected Center Sheet Metal, Inc. 15 times in New York since 1981.
The latest one began on Jul 10, 2017 on a referral, in Brooklyn.
Those inspections ended with 37 citation items: 20 serious and 17 other-than-serious.
Penalties were first proposed at $34,591 and now stand at $23,260, 33% lower after settlements or reviews.
Ground-fault protection on job sites comes up most often in these citations: 4 items under 1926.404.
How that compares: the median penalty per cited inspection for manufacturing employers since 2015 is $3,600, and Center Sheet Metal, Inc. averages $12,000 (1 cited inspection).
Center Sheet Metal, Inc. also files yearly injury logs with OSHA, summarized below.
It reported 1 severe injury to OSHA since 2015.
Citation items per year, by inspection date.
New York · latest 90 days of OSHA records
361employers cited
2 of them in the same industry
Get notified the morning OSHA posts each new citation in New York: the employer, the site address, the rules broken and the penalty.
From the Form 300A summaries employers file with OSHA each year. Rate = recordable cases per 100 full-time workers.
In 2023, the Bronx site logged 1 recordable injury or illness among about 30 workers: 4.7 per 100 full-time workers, against a median of 3.6 for its industry. Those cases cost 10 days away from work.
Site and year
Workers
Cases
Days-away cases
Rate
Industry median
Center Sheet Metal, Inc.
Bronx · 2023
30
1
1
4.7
3.6
Included with any plan: 1 more yearly log from these sites, back to 2022, with each site's average rate over its latest three years. Already a subscriber? Sign in.
(b) Implementation—(1) What do I need to do to complete the OSHA 300 Log? You must enter information about your business at the top of the OSHA 300 Log, enter a one or two line description for each recordable injury or illness, and summarize this information on the OSHA 300-A at the end of the year.
(i) Engineering controls and work practices for brake and clutch repair and service. During automotive brake and clutch inspection, disassembly, repair and assembly operations, the employer shall institute engineering controls and work practices to reduce employee exposure to materials containing asbestos using a negative pressure enclosure/HEPA vacuum system method or low pressure/wet cleaning method, which meets the detailed requirements set out in appendix F to this section. The employer may also comply using an equivalent method which follows written procedures which the employer demonstrates can achieve results equivalent to Method A in appendix F to this section. For facilities in which no more than 5 pair of brakes or 5 clutches are inspected, disassembled, repaired, or assembled per week, the method set forth in paragraph [D] of appendix F to this section may be used.
Alert subscribers get notified of each newly cited employer in New York the morning it is posted. See the alert plans.
Source: U.S. Department of Labor, OSHA enforcement data. A citation is OSHA's allegation; employers can contest it, and the status column shows where each item stands. Something wrong on this page? Tell us.